PocketWizard CM-N3-ACC Canon MD Remote

*Only for use with MultiMAX with ACC port, MiniTT1 and FlexTT5. Not for Plus II.

-ACC Cables are a special kind of Pre-Trigger cable for use with the new FlexTT5 or the
latest MultiMAX. Toggle Pre-Trigger on and off remotely with the MultiMAX. Required for
remote camera triggering with a FlexTT5 if using E-TTL functions. NOTE: An older mono
motor drive cable and/or pre-release cable can be used instead of an -ACC cable with a
FlexTT5 but you will not have E-TTL capability.

This cable contains a pre-trigger connection. When a remote zone is enabled on a
MultiMAX, the camera behaves as if the camera's shutter release button were held half-
pressed continuously. This makes the camera respond more quickly and consistently, but also
consumes the camera's batteries much more quickly. When the remote zone is disabled, the
camera will enter its normal sleep modes.

Compatible with cameras using Canon's N3 Remote Terminal including:

• Canon:
  • EOS-1D Mark III EOS D30
  • EOS 20D

  • EOS-1D Mark II N EOS D60
  • EOS 30D
  • EOS-1Ds Mark III EOS 5D
  • EOS 40D
  • EOS D2000 EOS 10D
  • EOS-1D
  • EOS-1Ds
  • EOS-1Ds Mark II
  • EOS-1V HS EOS-1Ds
  • EOS-1D Mark II
  • EOS-3
  • EOS-1V

• Kodak:
  • DCS 520
  • DCS 560